FAB 50
FAB 50
| FAB 50 | |
 | |
| Name | FAB 50 |
|---|---|
| Manufacturer | Fab |
| Lock Type | Cylinder |
| Lock Design | Pin-tumbler |
FAB 50 is the low end of FAB's portfolio; it belongs to a resistance class 1, which means it is meant to be used for temporarily locking objects without providing much security.
Description
The lock contains five pin stacks, with two chambers containing standard drivers, and three chambers contain spools. These spools, along with usually quite agresive bitting do provide some basic anti-picking protection. The profile used (R14) is not paracentric, and there is no anti-drill or anti-bumping protection.
Dissassembly instructions
To disassemble a double euro cylinder, use of a pinning shoe is the preferred method.
Other possibility is to use a segmented follower, but that requires that both cores are pulled out a bit to allow a cam removal. Then a core should be rotated to approximately 4:30 or 7:30 o'clock position (135 degrees either clockwise or anti-clockwise) to prevent driver entering a gaps for the cam clutch. Then a segmented follower can be used to remove the core.
Vulnerabilities
The FAB 50 is vulnerable to one or more of the following:
Gallery
Detail of FAB 50 key pins and driver pins.
Detail of the FAB 50 keyway.
Examples of FAB 50 key bitting.
References
