Testing-mgsecure: Difference between revisions

From Lockwiki
Jump to navigationJump to search
mNo edit summary
mNo edit summary
Line 25: Line 25:


TBD
TBD
== Thumbnail test ==
<gallery widths=200px heights=200px align="center">
File:Mastercommercial.JPG | [[Master Lock No 1]]
File:Master130.JPG | [[Master Lock No 130]]
File:Master-140-front.jpg | [[Master Lock No 140]]
File:Master-141-front.jpg | [[Master Lock No 141]]
File:Master Lock 142 - FXE48039.jpg | [[Master Lock No 142]]
File:Master Lock 150 - FXE47400.jpg | [[Master Lock No 150]]
File:Master175XDLF-front.JPG | [[Master Lock No 175]]
File:MasterNo2.jpeg | [[Master Lock No 2]]
File:MasterNo22.jpg | [[Master Lock No 22]]
File:Master2240.JPG | [[Master Lock No 2240]]
File:Master Lock 3 - FXE47401.jpg | [[Master Lock No 3]]
File:MasterNo4.jpg | [[Master Lock No 4]]
File:Master Lock 410 LOTO, orange - FXE47410.jpg | [[Master Lock No 410]]
File:Master 570.jpg | [[Master Lock No 570]]
File:Master605.JPG | [[Master Lock No 605]]
File:Master975-front.jpg | [[Master Lock No 975]]
File:Lock Sphero.jpg | [[Master Lock Sphero]]
</gallery>


== ALL lock photos ==
== ALL lock photos ==

Revision as of 21:40, 30 January 2023


This page being used for testing and development




Disassembly instructions edit

Original: To disassemble a double euro cylinder, use of a pinning shoe is the preferred method. Other possibility is to use a segmented follower, but that requires that both cores are pulled out a bit to allow a cam removal. Then a core should be rotated to approximately 4:30 or 7:30 o'clock position (135 degrees either clockwise or anti-clockwise) to prevent driver entering a gaps for the cam clutch. Then a segmented follower can be used to remove the core.

Proposed edit:

For Euro Profile page:

The use of a pinning shoe is the preferred method for disassembling a double euro cylinder. STEPS?

Another method is to use a segmented follower. The c-clips retaining both cores must first be removed and then both cores can be pulled out slightly in order to remove the center cam. One core should be rotated 30-45 degrees either clockwise or counter-clockwise -- once the cam is removed. This allows the core to be removed without driver pins entering gaps for the cam clutch. At that point, a segmented follower can be used to remove the core.

Locks not intended for installation and use can be disassembled in a quick but destructive procedure. The cylinder housing itself can be cut in the middle using a hacksaw or grinder. The cam will no longer be held in place and can be removed. The resulting two cut half euro cylinders can then be disassembled as outlined above.

For individual lock page:

TBD


Thumbnail test


ALL lock photos

Test gallery